A guided punch that fits in the rails of the upper, aligning a punch pin to drive out the gas piston using the BCG.<\/p>\n
\u00a0<\/p>\n
IMPROVED DESIGN!\u00a0 Now with threaded stud, so it can be driven by the Bolt Carrier, or mounted on the end of a cleaning rod.<\/p>\n
\u00a0<\/p>\n
This is a delrin block, CNC machined to fit in the rails of the upper, which positions a small punch pin to extract the piston for cleaning.\u00a0 There are other ways to get cleaning rods or other tools in there to drive the piston out for cleaning, but using the tool that\u2019s designed for the job makes it just that much easier.<\/p>\n
\u00a0<\/p>\n
This punch is included in the SCARmorer tool, but in case you want a spare, or in case you already have an FN tool kit assembled, you can buy this piece separately.<\/p>\n
\u00a0<\/p>\n
\u00a0<\/p>\n
Made in USA.<\/p>\n","protected":false},"excerpt":{"rendered":"
A guided punch that fits in the rails of the upper, aligning a punch pin to drive out the gas piston using the BCG. \u00a0 IMPROVED DESIGN!\u00a0 Now with threaded stud, so it can be driven by the Bolt Carrier, or mounted on the end of a cleaning rod. \u00a0 This is a delrin block, […]<\/p>\n","protected":false},"featured_media":4604,"comment_status":"open","ping_status":"closed","template":"","meta":{"om_disable_all_campaigns":false,"_monsterinsights_skip_tracking":false,"_monsterinsights_sitenote_active":false,"_monsterinsights_sitenote_note":"","_monsterinsights_sitenote_category":0},"product_cat":[201,19,164,28],"product_tag":[],"aioseo_notices":[],"aioseo_head":"\n\t\t\n\t\n\t\n\t\n\t\n\t\t\n\t\t\n\t\t\n\t\t\n\t\t\n\t\t\n\t\t\n\t\t\n\t\t\n\t\t\n\t\t\n\t\t