National Match Prepped, this hammer is the only M1 \/ M14 hammer to ever offer drop-in NM performance, along with a 25%
\nreduction in lock time (hammer swing time).<\/p>\n
Polished, ground, and fully hardened sear edge will release the hammer like breaking a glass rod.
\nA hard \/ low friction surface coat makes the trigger pull butter smooth and eliminates wear.
\nAll parts are true ‘drop-in’ with no additional fitting, polishing, or tuning required on the parts or on the rifle.<\/p>\n
Lock time is the time between when the trigger releases the hammer, and the hammer hits the firing pin.\u00a0 That’s time during
\nwhich the rifle is typically swinging off-target.\u00a0 Especially in offhand shooting, if shots are broken as you are moving ‘off-target’,
\nthat delay can cost points.<\/p>\n
The ShootingSight NM Hammer is machined from billet steel to be light weight, reducing polar moment by 40%, and optimizing
\ngeometry for speed. Lock time is reduced 25% from 8.5ms to 6.5ms; which is as fast as a mil-spec hammer on an AR-15.<\/p>\n
Sear edges are ground and polished to be sharp before an ultra hard and low friction surface coating is added.\u00a0 The result is a
\nsmooth trigger pull, and a clean break which will not wear.<\/p>\n
Comes with a new tool-steel hammer pin.<\/p>\n
Consumer Comments:<\/p>\n
“These are worth every cent you pay for them. Try one in a match, you will never it have any other way. I got them in my match
\nconditioned 14s and in my McCoy M1. When I can afford another one, it will go in my other McCoy M1.”\u00a0 Nez R.<\/p>\n
“It’s fantastic.\u00a0 Predictable, and so FAST!\u00a0 Whole system feels like running a bolt action.\u00a0 I like the feel of your NM better than
\nothers, which to me interpose a disconnect at the junction of subconscious\/trigger break, which make it difficult to ‘time’ a shot.”
\nCharlie M.<\/p>\n
Installation instructions M14 trigger<\/a><\/p>\n Warranty and Terms M14<\/a><\/p>\n Installation Video<\/a><\/p>\n